So… a week and an half ago, just getting over the flu I’d had for two weeks, I decided I needed a second wooden spatula in the kitchen. So I made one from cherry. And broke it when I put in the inlay of ash which was just a hair too big.

The cherry spatula is 3 inches wide. The maple ones are 3½ inches wide. The blades vary in length from 3 to 4 inches.

Then I made five more from maple because I figured I could do better. I had planned to get four from a 12/4 x 7 inch x 20 inch chunk of maple, but after cutting the first two out, I realized I could get three from the thickness I had. And if the board were 9 inches wide, I could probably get nine blanks from a 20-22” long piece. But anyway.

Roughed them all out on the bandsaw, changing blades way too often. Had a ¾” 2/3 tpi hook blade for ripping / resawing out each spatula shaped piece from the 12/4 board, then a ¼” 16 tpi blade for cutting out the shape.

From there, the blanks went into the carving vise, and I dialed in the shape with spokeshaves. I used the large and small HNT Gordon shaves, as they both have tight enough mouths that I can work the “wrong way” on the grain and still not get bad tear-out.

On a few of the spats, I used the belt sander to flatten the back of the blade, but generally I did that with the large shave. I think the two with the worst blades were ones I cut with the tension too low on the resaw blade.

Carving was mostly done with a 45°︎ V tool palm-gouge. I think it’s 3mm wide. I also used a #3x6mm and a #2x12mm on the blue and yellow spat. The plum painted ones just got lines carved with the v-tool and then I made some thin plum milk-paint and painted it into the lines.

#woodworking #batchProduction

Discuss... Or contact me in the fediverse @davepolaschek@writing.exchange